Well, in a nutshell, the only thing holding the barrel into the receiver in a 10/22 is the V-block with the two allen screws, which compared to something like threading is a pretty weak way to hold a barrel into a reciever. As a result, the barrels of many 10/22s sag as they run down the stock. The idea is to bed the first few inches from the breech so as to provide a stable enough "foundation" to be able to float the rest of the barrel, if that makes any sense. If you just tried to float the barrel through another method, the barrel would still sag and you'd get sub-par results. With heavier bull barrels like your proposed Green Mountain I'm told another pressure point near the muzzle is required to keep the barrel from continuing to sag.
That's as I understand it at least. Whatever the logic behind it may be, I bought the $20 bedding kit from MidwayUSA, bedded those first few inches of the stock and sanded the rest to float the barrel, and it cut my groups with a stock 10/22 by about a third. I only shoot offhand though, and as always YMMV.
Also, I have a tuffer buffer in mine (it was the cheapest of its sort), I don't suppose it's much better than any other polyurethane buffer, but it sure does reduce action noise and it doesn't rattle around in the receiver like the steel buffer.
That's as I understand it at least. Whatever the logic behind it may be, I bought the $20 bedding kit from MidwayUSA, bedded those first few inches of the stock and sanded the rest to float the barrel, and it cut my groups with a stock 10/22 by about a third. I only shoot offhand though, and as always YMMV.
Also, I have a tuffer buffer in mine (it was the cheapest of its sort), I don't suppose it's much better than any other polyurethane buffer, but it sure does reduce action noise and it doesn't rattle around in the receiver like the steel buffer.


Comment