Red dot for Buckmark Contour ?

[newbie1234]

The BM Contour has three screws on the top plate, when I mount the Bushnell TRS-25, the red-dot covered the middle screw, whenever I clean the pistol I have to remove the red-dot before I can field strip the pistol. Then after clean the pistol I had to re-mount the red dot and zero it again, it's a pain ... .

I found a mini red dot on Opticsplanet and the price is very reasonable , I wonder that:
(1) Anny of Calgunner had this red-dot ?
(2) Is the quality of this red-dot as same as Bushnell TRS-25 or it just like all the bull sh*t $20 red-dot that we can find everywhere on Amazon ?
(3) Does this red-dot cover the middle screw after mounted ?
(4) If you had one red-dot that does not cover the middle screw then let me know the brand and model, very thanks.

https://www.opticsplanet.com/opticsplanet-red-dot-mini-reflex-sight-w-fully-multi-coated-lens.html

and for your references.

[chomorro]

I just put this cheap one on. Bore sighted but haven't range tested yet. I have a trs 25 I was going to use a quick disconnect rail mount on. That might solve your issue but it will be mounted higher

Sent from my SM-N910V using Tapatalk

[newbie1234]

I just put this cheap one on. Bore sighted but haven't range tested yet. I have a trs 25 I was going to use a quick disconnect rail mount on. That might solve your issue but it will be mounted higher

Sent from my SM-N910V using Tapatalk

Thanks you for your reply, but I did not want to remove the rear sight.

[chomorro]

Oh ok. I would look at a quick disconnect low profile mount for the trs or if it's on a mount it may clear that screw on its own.

Not sure though, I don't own a contour

Sent from my SM-N910V using Tapatalk