JC Higgins Model 103.229 Part Needed

[Bull Elk]

Need a magazine tube band and pin for the above model. Numrich has just about all parts for this model....except for this one. Any leads would be appreciated.

BE

[TRAP55]

Says out of stock, but you click to order, and they'll put you on an email list for the next one that comes in. I've had good luck with them getting hard to find parts.

http://cfnparts.com/index.php?route=product/category&path=347

Call Bob and check with him too.

http://www.gun-parts.com/marlin/

[Red-Osier]

I was going to say Numrich, But I guess not.

['ol shooter]

so it looks like you have a Marlin mod 81
this piece came from early Glenfield mod 60
from eyeballing pictures it looks like the style you are looking for
if you think it will fit pm address and I will mail it to you

You need to measure the size of the dovetail slot in the barrel, there are two sizes. My Sears 43 (Marlin 81 DL) has the wider slot. I think the one pictured has the small slot. I ordered one some years back, and they only had the small one, it looked like the one shown here. The correct one for mine does not curve in on the sides the way the one pictured does. Worst case scenario, you could make one for it. One hole and some file work on a chunk of steel would do it. Very generous of John Myers to offer it to you.