So I picked up a cmmg dedicated upper, and installed a 12.37" samson evolution free float tube on it. Just noticed today the the rail curves up at least a couple mm. Which I imagine is going to create havoc with the iron sights I planned on putting on it. Any one have any experience/ tips? I searched the web found very few similar experiences other people had and said they just held the rail down while tightening to fix it. Well I applied pressure downward on the upper today while retighening the set screws ( with the top rail laying parralel to the table top) when I picked it up to check its still curving up. Any thoughts? Need to apply more pressure? Something else causing this? Any help greatly appreciated. Thanks
Unconfigured Ad Widget
Collapse
|
|
|
|
|
|
|
|
Samson evolution rail
Collapse
X
-
Just a suggestion, but I would lay a straight edge on it like a level or a ruler, snap a couple photos, and email the retailer for a replacement. I cannot think of a valid reason that top rail would not be perfectly level all the way down. Good luck."It is better to remain silent and be thought a fool, than to open one's mouth and remove all doubt."
Abraham Lincoln -
Agree with the poster above. Have Samson fix it. it's their defective product. I have a Samson rail on my stag and its perfectsigpicComment
Calguns.net Statistics
Collapse
Topics: 1,870,990
Posts: 25,178,273
Members: 358,862
Active Members: 5,382
Welcome to our newest member, 1776 Arms.
What's Going On
Collapse
There are currently 34239 users online. 113 members and 34126 guests.
Most users ever online was 239,041 at 11:39 PM on 02-14-2026.

Comment