Help mounting Burris AR-332 on M16A2 carry handle!

[Zippiot]

After looking at some pictures online of the optic mounted on the A2 carry handle I noticed I do not have that giant, specialized bolt/screw used to attach it. Without said screw, the optic simply flops around with each shot.
Does anybody know where to get the bolt/screw? If it came in the box... I may be hosed

Thanks!


I see this same looking bolt all over on different mounts, so its likely that its some standardized bolt I am just unaware of.

[Zippiot]

I wonder if those QD type screws for the ACOG will work


From near the bottom of this page:

http://www.pkfirearms.com/Other_Scope_Mounts/118/c

[PrimaryArms]

https://www.primaryarms.com/Carry_HandleThumb_Screw_for_Primary_Arms_3X_scope_p/pachts.htm

Here u go

Dimitri

[Zippiot]

Perfect, thank you!!

[PrimaryArms]

Perfect, thank you!!

No problem

Dimitri

[Zippiot]

Before I go I want to ask a few questions:
I noticed it didnt say specifically that the thumb screw would fit the burris, the screw from the burris was too small and allowed it to wiggle in the hole in the carry handle.
I found a few of those ACOG screws that appear to have a molded washer which cradles the contour of the carry handle, Ill check with some of the M16's here that have ACOG's mounted on the A2 carry handle for bolt fit.

[PrimaryArms]

Before I go I want to ask a few questions:
I noticed it didnt say specifically that the thumb screw would fit the burris, the screw from the burris was too small and allowed it to wiggle in the hole in the carry handle.
I found a few of those ACOG screws that appear to have a molded washer which cradles the contour of the carry handle, Ill check with some of the M16's here that have ACOG's mounted on the A2 carry handle for bolt fit.

It will fit the Burris it's the same specs

Dimitri