LMT missing part?

[novabrian]

Does anyone know where I can get the piece i'm missing on my sight?It's the piece that slides onto the bolt and sandwiches the mount to the upper rail.

[rct442]

I don't know what you're talking about. Got any pics?

If you're describing what I think you are, then that shouldn't happen. LMT properly stakes the thumb screws so you can't remove them.

[novabrian]

The piece opposite of this side.

[rct442]

Where did you get it? Like I said LMT properly stakes those thumb screws. There should be a X on the end of that screw.

Somebody must have gone to town on it by the looks of the last photo.

[novabrian]

I got it used.LMT wont sell the part to me boooo!! They want me to buy a whole new one WTF??

[rct442]

Who the **** sold it like that to you? Out the bastard.

I kind of have to agree with LMT on this one. Somebody clearly made aftermarket modifications to it. You're best bet is to get a refund from the guy who sold it like that.

Good luck.

[tacticalcity]

Ask one of the DIY machinists on here to make the part for you. You can find them in the GUNSMITHING section.

[novabrian]

Who the **** sold it like that to you? Out the bastard.

I kind of have to agree with LMT on this one. Somebody clearly made aftermarket modifications to it. You're best bet is to get a refund from the guy who sold it like that.

Good luck.

no I don't want to out the guy cause this was a throw in on an upper I bought from him.He is a great calgunner.I could make one if I had a mill.Is this a good enough reason to buy a lathe and a mill combo machine?

[patriot_man]

no I don't want to out the guy cause this was a throw in on an upper I bought from him.He is a great calgunner.I could make one if I had a mill.Is this a good enough reason to buy a lathe and a mill combo machine?

Just get someone to make it for you or you could get a carry handle and use the parts off that and cut it down a bit.