Help w/Aimpoint PRO zero

[jj19]

My aimpoint pro that I've owned new since 2015 seems off too me. Its currently mounted on a M68 CCO mount w/ 1/3 cowitness.

So I confirmed zero first on my irons but when I go to initially place the rds reticle lollipop style on the front post and shoot a few rounds, they land far left at 25 yards. Then it seems like the more I try to adjust the windage to zero at 25yrds, shots still land left while elevatation is good. I think I turned the windage to the right more than 40 clicks but my rds is still off. And looking at the rds reticle through irons, the dot is far right of the center post and almost touching the right end of the front post. Calgunners please help!!!

[Sliik]

reset the ap to factory zero and go from there.

[Sliik]

The manual usually tells you how you do it it's different from brands but it's usually a full 360 on windage/elevation but some are different just check the manual for a factory reset and just rezero it at lower 1/3rd

[jj19]

Awesome thanks!!

[Siberian23]

Make sure after you reset that when you lollipop it on the front sight you are looking through the rear as well to line it all up.

[jj19]

Went and factory zeroed my irons. Did the same for my aimpoint by turning both knobs clockwise all the way until i felt tension. Removed/reinserted the battery then lollipopped the rds above the fsp. Then headed to the range today and made the correct adjustments which thankfully resulted in the optic shooting bullseyes again at 25yards!!! Thanks for the help calgunners!