Stock for SKS with screw-in barrel?

[Standard]

I bought a replacement stock for my Factory 26 Chinese SKS with a screw in barrel, but the stock won't fit as the cross-bolt gets in the way of the barrel. Apparently the press-in barrels use a different cross bolt.
Any ideas on where to find a decent replacement stock for something like mine?
This is the original stock that I'm replacing

Thanks!

[Standard]

Thanks for the tip. It looks like they have grade II and grade III only, which are cracked? What grade is that one?

[Lurch762]

Is the crossbolt hole itself in a different location or is the shape of the crossbolt different? If the crossbolt itself is different, can't you just swap them? Just remember, the slotted head does not turn, it's only there to hold the crossbolt from spinning while tightening up the side that uses a spanner.

[Standard]

Well, after 30 minutes with the dremel, it fits
I just ground down the cross bolt and a couple of the stock areas to make it fit.

[BroncoBob]

Hye Remy looks like you got it fixed. I had to do some same modifications to a stock I replaced.

[Standard]

Oh, good to know. I hope you didn't encounter any problems afterwards?
I'm not sure what could really go wrong with a weaker crossbolt, but still?
Haven't seen you out at BLM in a while!

[454kahuna]

Where else would one pick up a replacement stock, for Chinese factory 26
sks?