Need help finding Mauser 24/47 Part

[wang949]

Looking for bases to mount on a Yugo M24/47 receiver. I bought these Warne bases for "Mauser 98 unaltered", but the rear base is way higher than the front for the M24/47

http://www.brownells.com/optics-mounting/scope-bases/rifle-bases/maxima-2-piece-base-sets-prod24131.aspx?avs|Make~~Model_1=Mauser__98

Any help?

[wang949]

anyone?

[TRAP55]

The rear base is higher because the rear receiver ring is lower. "Unaltered" means the stripper clip guide ears haven't been ground off and the rear ring radiused.
"Altered" means it has and takes a different rear base.

[wang949]

The stripper clip guides are still intact. The receiver is original, but the base is too high. I believe it has something to do with 98 vs 24. Still searching for a correct base. :/

[wang949]

The stripper clip guides are still intact. The receiver is original, but the base is too high. I believe it has something to do with 98 vs 24. Still searching for a correct base. :/

[6mmintl]

bases reversed?

[wang949]

No, they are in the correct position. I think the specs on a 98 and a 24 are different. Anyone know of bases for the M24/47?

[wang949]

Should I have gotten the "FN (military model)" bases from Warne, since the Yugo M24/47 is a variant of the FN24?

[TRAP55]

LR 98 receiver dimensions are all pretty much the same regardless of the action length, with a 1.410 diameter receiver ring. Are you positive it's higher, or does it just look higher?
Clamp the bbl'ed action down and use a bubble level to make sure it's level. Place the mounts where they are supposed to be and lay the level on top. If it's not level, Brownell's sent ya the wrong mounts.

[6mmintl]

EGW has picatinny rail mt for std. mauser actions.

[wang949]

LR 98 receiver dimensions are all pretty much the same regardless of the action length, with a 1.410 diameter receiver ring. Are you positive it's higher, or does it just look higher?
Clamp the bbl'ed action down and use a bubble level to make sure it's level. Place the mounts where they are supposed to be and lay the level on top. If it's not level, Brownell's sent ya the wrong mounts.

I am positive. The rear mount is higher than the front.