Double check me on this scope mount please...

[XDRoX]

Before I order would you guys please double check my measurements to make sure this mount will work with my rifle?
Thanks

Here's the scope dimensions:

A: 14.5
B: 5.2
C: 2.0
D: 1.9
E: 3.65
F: 5.8
G: 2.51
H: 1.65

Here's the mount I want:




C:1.50"
D:4.17"
E:2.15"




...

[CK_32]

Centerline of the scope Obj lens should be 1.255 above the rail. Your rings say 1.5 so you should have .255" to spare.

That said what is the D and E measurement? Be sure the rings will sit and not contact the bells of the scope.


Also before you buy take a look at ADM. QD levers and solid AR scope rings and have several options. Just throwing that out there if you haven't given them a look yet, to make sure you get the most for your $$ and rifle mount.

GL

[XDRoX]

Centerline of the scope Obj lens should be 1.255 above the rail. Your rings say 1.5 so you should have .255" to spare.

That said what is the D and E measurement? Be sure the rings will sit and not contact the bells of the scope.


Also before you buy take a look at ADM. QD levers and solid AR scope rings and have several options. Just throwing that out there if you haven't given them a look yet, to make sure you get the most for your $$ and rifle mount.

GL

Thanks. I edited my OP.
And I will check out the ADM.

[Trriemferent]

I found a few sites that were pretty useful to me

http://www.mil-rad.com/scope_ring_calculator

http://www.mil-rad.com/scope_cant_calculator

http://www.mil-rad.com/scopes

http://www.mil-rad.com/rings

[kcheung2]

Unless you're using a 50mm+ objective, PEPR mounts accommodate most common sized scopes.

[russ69]

Before I order would you guys please double check my measurements to make sure this mount will work with my rifle?...

It might help if you tell us what rifle, just saying.

[XDRoX]

It might help if you tell us what rifle, just saying.

This upper.

[jdben92883]

You sure you've got your dimensions correct? You have 2.51" O.D. for "G"...that would be close to a 60mm objective!!

P.E.P.R.s hold the optics pretty high. Even if your 2.51" is accurate, you would be fine with a P.E.P.R.

[XDRoX]

It's a 50mm scope. I may just take the scope to LGS tonight and see what they have in stock.

[BrassCase]

I have a Larue QD mount and the Burris QD PEPR mount. Both work well. The rails section caps for the Burris are optional to install, it comes with the rail caps and plain caps.