same ak receiver re-useable?

[Armed-Citizen]

if i built on ak on a receiver and decide to build another ak, can i use the same receiver or is the receiver a one time use once its been attached to an akparts kit?
just curious

[AKSOG]

If you know how or have somebody demill it without destroying it, I dont see why not. I have seen people do it with nodaks

[Armed-Citizen]

btw, are polish ak 47 parts kit a decent kit?
how would it compare in quality to other parts kits from other countries?

[JKMIII]

Sounds like your asking if an AK is like and AR and you can switch the upper. If so, the answer is no.

If your asking if you could cut the rivets of a reciver and disassemble the gun, then re-rivet another kit onto that reciver, I think that might be possible, but not sure.

[bohoki]

depends on your skills

[peppermintman]

Sounds like your asking if an AK is like and AR and you can switch the upper. If so, the answer is no.

If your asking if you could cut the rivets of a reciver and disassemble the gun, then re-rivet another kit onto that reciver, I think that might be possible, but not sure.

[CSACANNONEER]

You could always reuse a receiver as long as you know what you are doing. But, if you're planning on making your own receiver, you might as well just make two to begin with. In the long run it would be cheaper and easier to do.

[ae13291]

what are you trying to do exactly? it may be difficult to have a different trunnion line up on the holes and be lined with the rails and mag catch. i guess it doesn't hurt to try.

[Armed-Citizen]

was curious if it was possible just re do another ak on a used reciever.

[MrPlink]

Unless there is something wrong with all the parts of the one you have now what is the point?

[ar15barrels]

was curious if it was possible just re do another ak on a used reciever.

The main reason people demill their AK's and rebuild them is because something went wrong with the receiver.
It could be rail problems or the carrier not sliding properly or the trunions ending up crooked in the receiver.

All of these are fixed by making a new receiver.

[G-Man WC]

Months ago under the watchful eye of Nico, I was able to demill and salvage a Spud.
Replacing it with a free world flat. I have seen the light! -g

[nicoroshi]

Months ago under the watchful eye of Nico, I was able to demill and salvage a Spud.
Replacing it with a free world flat. I have seen the light! -g

Pics or it never happened.





















Lmao

[G-Man WC]

No face or tattoo pic's bro. You know the rules!

[dshooter]

It is possible, but it will be a pain the butt trying to demill all the rivets. You're more likely damage it more in the demilling process than just buying a new flat. Front trunion may be off and may not be aligned with the rails. Best to just pay $25 for another flat and bend it.