Reputable Engraver for 80% in Inland Empire ?

[odslim]

Getting my 80% milled out today, and unfortunately they dont do engravings. Can anyone recommend a reputable shop around the I.E specifically the Corona, Riverside area. Im also willing to travel to the OC if need be...

I would definitely go with Sure Shot Precision, but San Fernando is a bit too far and I think he's backed up for a bit.

Thanks

[valley82]

The only one I have experience with is...

The Engraving Place
760-727-5085 • Fax: 760-727-8136
756 S. Rancho Santa Fe Road
San Marcos, CA 92078

[lavey29]

I have used Danco in Ontario for engraving.

[camvoncrosshair]

Vader Spade does some awesome work. I know its too late since you are getting you lower receiver milled today, and you have to send it to him incomplete/non 100%.

I am hoping my 80's will be in withing the next week or so. Then just have to wait a bit to get them milled.

[ke6guj]

I have used Danco in Ontario for engraving.

do they offer while-you-wait engraving?

[lavey29]

I don't think so but then again, I did not ask about it. I think the Ontario shop actually sends it over to the Monrovia shop for the engraving and they do the anodizing at Ontario.

[lavey29]

Vader Spade does some awesome work. I know its too late since you are getting you lower receiver milled today, and you have to send it to him incomplete/non 100%.

I am hoping my 80's will be in withing the next week or so. Then just have to wait a bit to get them milled.

Yes, I have viewed his pictures of engraving and it looks terrific. Better then what I had done IMO.

[bigdawg86]

Bump, looking for same info.

[hellayella]

DANCO...what are they? do they deal with gun stuff? or will freak out once u drop a receiver on their lap?

[Danomite556]

Can you show us some pics of their work on your firearms?

[crazyucbr]

I have used Danco in Ontario for engraving.

Post some pics pls

[golfish]

please, let see some pictures of Danco's work.

[razorduc]

DANCO...what are they? do they deal with gun stuff? or will freak out once u drop a receiver on their lap?

I believe Danco will only do 80%. They didn't have an FFL last year when I checked.

[IrishJoe3]

Thought I'd give a shout out to Vader Spade..... I just got my receiver from him. I was hesitant to have him do my engraving as I wanted to get it laser etched, but wow! He did a great job!







These pictures don't show the detail. On the Army crest, the banner in the eagles mouth actually has E Pluribus Unum etched in it.

Thanks Randy! Awesome work!