Tweet
I've read the threads on the install but just for my peace of mind I'm gonna ask anyway 
installing the BC 1.5, using the crush washer provided, I hand tightened to about 11 o'clock (if top is is 12o'clock) then torqued it down so the logo ended up at 6 o'clock. I tightened with a wrench to 1 o'clock twice, then backed off. After that it was smooth sailing to the 6 o'clock position...this is where my concern comes in. It felt like it could've kept going easily. Mind you, no use of a vise here, just standing on the receiver. Any reason for concern?
BC site does say no more that 25lbs while torquing. So it's probably fine.
installing the BC 1.5, using the crush washer provided, I hand tightened to about 11 o'clock (if top is is 12o'clock) then torqued it down so the logo ended up at 6 o'clock. I tightened with a wrench to 1 o'clock twice, then backed off. After that it was smooth sailing to the 6 o'clock position...this is where my concern comes in. It felt like it could've kept going easily. Mind you, no use of a vise here, just standing on the receiver. Any reason for concern? BC site does say no more that 25lbs while torquing. So it's probably fine.
Comment