Type III Hard Anodizing Source

[Press Check]

I have a stripped AR receiver that's old, scratched, marred, etc., and wanted to have it chemically stripped and re-anodized. Does anyone have a firearm friendly source to have this done in SoCal?

[Thordo]

Hi Press check,
Tech plate is in Anaheim and they have an FFL. Here's the link.

http://www.techplate.com/firearms_pl.htm

Thordo

[Arkangel]

PM Roccobro, he can help.

[Lc17smp]

Hi Press check,
Tech plate is in Anaheim and they have an FFL. Here's the link.

http://www.techplate.com/firearms_pl.htm

Thordo

Make sure you can grab your ankles before you call.

[Dakine_surf]

Where are you located?

[Press Check]

LA County (SFV).

[cmace22]

Chemically stripping the old ano will most likely change the tolerances of the lower. Best bet is to Molly Resin the lower to match the upper. They may be able to strip after masking but Ive always been told it will change the dimension significantly.

[cmace22]

Just looked at the prices for the anodizer above. By their price sheet your looking at $230 without masking charges. Unless that lower has significant meaning to you, you would save a ton of cash by just buying a new one.

[Dakine_surf]

Bummer, I know a guy near me who anodizes, but it is quite a ways from LA (about 2 hours.)

[WDE91]

PM Roccobro, he can help.

$25 per piece
He is doing two lowers for me right now that started life as 80%ers

[Press Check]

$25 per piece
He is doing two lowers for me right now that started life as 80%ers

Someone's only charging $25 for Type III anodizing?

[Press Check]

Chemically stripping the old ano will most likely change the tolerances of the lower. Best bet is to Molly Resin the lower to match the upper. They may be able to strip after masking but Ive always been told it will change the dimension significantly.

If I'm not mistaken, you lose .0001-.0030, depending on the original build-up.

[Press Check]

Bummer, I know a guy near me who anodizes, but it is quite a ways from LA (about 2 hours.)

Not opposed to shipping and allowing someone to "borrow" my stripped lower.

[baih777]

Someone's only charging $25 for Type III anodizing?

he waits till he gets enough to get a batch deal. its worth the wait.