BB question

[No Good]

Hi, this is my first time installing a BB and I was wondering how far it seats down into the receiver? I know its suppose to be snug but damn.

O its a Stag lower if that makes a difference!

[mike452]

All the way until it hits bottom..

[No Good]

All the way until it hits bottom..

So does it sit flush or stick out the same distance as the the stock release?

[hoffmang]

It sticks out about as far as the stock button usually stood out - maybe a 1/8" more.

-Gene

[No Good]

It sticks out about as far as the stock button usually stood out - maybe a 1/8" more.

-Gene

OK thats what I was looking for.
Thanks for your help.

[shark92651]

The BB will protude 5/16" when completely seated into the receiver.

[calAWBsux]

How hard is it to get the BB out once its installed? I go to Neveda a lot, so I was just wondering.

[J_Rock]

If you did not file down the burr and had to hammer it into its place with a mallet then I'll take vice grip and some muscle to get it out.

[Prince50]

Even if you did not file, you can tap it out from the left side with the correct size punch. Pretty easy actually, got the tip from a Calgunner.

Darin

[supersonic]

Even if you did not file, you can tap it out from the left side with the correct size punch. Pretty easy actually, got the tip from a Calgunner.

Darin

Darin,
after you've removed a BB, let's say-in the future- you wanted to install a NEW one, would it fit as snug as before? (meaning: would punching it out create "engraved track marks" inside mag release button channel?)