Tweet
Was getting FTE, replaced the extractor spring with a heavy duty one from Sprinco. took it to the range today and the same FTE. Used my sons bolt and rifle ran fine. Thinking of a new bolt? any ideas.
-
-
So no problem cycling at all, just failing to extract? Will it extract if hand cycled? If it hand cycles fine there isn't a problem with the bolt. -
Yes this time FTE and FTF it did hand cycle.Comment
-
If it hand cycles, but gas doesn't cycle it, it sounds like a gas problem. Does your buffer tube, buffer spring and buffer all match? What buffer? What barrel are you using? Gas system length?Comment
-
chk gas key might be looseComment
-
Tighten the gas key."A nation can survive its fools, and even the ambitious. But it cannot survive treason from within. An enemy at the gates is less formidable, for he is known and carries his banner openly. But the traitor moves amongst those within the gate freely, his sly whispers rustling through all the alleys, heard in the very halls of government itself...A murderer is less to fear. The traitor is the plague."......CiceroComment
-
Ahhhhh Emy! I see what you did there!"A nation can survive its fools, and even the ambitious. But it cannot survive treason from within. An enemy at the gates is less formidable, for he is known and carries his banner openly. But the traitor moves amongst those within the gate freely, his sly whispers rustling through all the alleys, heard in the very halls of government itself...A murderer is less to fear. The traitor is the plague."......CiceroComment
-
had it happen with me at the range didn't have the tool to tighten ,went home earlyComment
-
I did replace the buffer spring with a blue one from Sprinco. I'll go back to the original one and check the gas key.Comment
There are currently 3569 users online. 139 members and 3430 guests.
Most users ever online was 65,177 at 8:20 PM on 09-21-2024.
Comment