Tweet
So i love my scar!
But i got an issue with my micro t1 on a knights armenant qd mount and my aimpoint 3x mag twistmount.
When i have 2 shims on the knights mount it lines up perfectly (really close) to the magnifier.... but my gun shoots 5" low at 50 yards with the t1 maxed out on as far up as i can get it. when i remove a shim, its lower than the magnifier and shoots fine but the dot is off center on the magnifier....
When i take the magnifier shim out, there is no where getting near to line up the the two, no matter the configurations.
So, whats my solution for getting the mount on the t1 and the twist mount to line up with the gun not shooting super low with the t1 maxed out on elevation and still able to co witness my iron sights?
But i got an issue with my micro t1 on a knights armenant qd mount and my aimpoint 3x mag twistmount.
When i have 2 shims on the knights mount it lines up perfectly (really close) to the magnifier.... but my gun shoots 5" low at 50 yards with the t1 maxed out on as far up as i can get it. when i remove a shim, its lower than the magnifier and shoots fine but the dot is off center on the magnifier....
When i take the magnifier shim out, there is no where getting near to line up the the two, no matter the configurations.
So, whats my solution for getting the mount on the t1 and the twist mount to line up with the gun not shooting super low with the t1 maxed out on elevation and still able to co witness my iron sights?
