AR config help

[SDlocal]

Ok guys I have my first AR built minus BUIS and flash hider (both on order) I have a question.

I have a MMG installed and cut down to fit an A2 entry stock. My question is because of the MMG could I get rid of the A2 stock and use a 6 position stock or does the drop free mag + 6 position stock make it an assualt weapon and there for not Kali legal?

[grammaton76]

I have a MMG installed and cut down to fit an A2 entry stock. My question is because of the MMG could I get rid of the A2 stock and use a 6 position stock or does the drop free mag + 6 position stock make it an assualt weapon and there for not Kali legal?

Yes, a collapsible stock turns it into an assault weapon. Do not do this.

[stevie]

If your mag is drop free, you cannot have any evil features.

[rips31]

cancel the order for the flash hider.

[Prc329]

cancel the order for the flash hider.

Yup, no flash hiders allowed.

[E Pluribus Unum]

Ok guys I have my first AR built minus BUIS and flash hider (both on order) I have a question.

I have a MMG installed and cut down to fit an A2 entry stock. My question is because of the MMG could I get rid of the A2 stock and use a 6 position stock or does the drop free mag + 6 position stock make it an assualt weapon and there for not Kali legal?

What I did was order a collapsable stock and installed it. When I found the appropriate stock length for me I pinned the stock and epoxied it so that it was no longer collapsable; this way the rifle fit me perfectly but it was within the law.

[Josh3239]

As long as you cannot make it collapse that's fine. Bushmaster made fixed collapsable stocks during the Federal AW ban.

[SDlocal]

Thanks guys and a correction it's muzzle break....the troy aggresive one very evil! It should scare the pants right off of Nancy Pelosi ...wait maybe that's a bad idea...let's say she won't like it!

[SDlocal]

P.S. How do you pin a stock?

[E Pluribus Unum]

P.S. How do you pin a stock?

I found a meaty spot where the two areas came together and drilled a very small hole between the inner and outer portion of the plastic. I then found a small cotter pin just slightly bigger than the hole. I then placed the cotter pin in a keyless chuck cordless drill. I heated the tip of the cotter pin and then "drilled" the cotter pin into the hole I had drilled previously.

This melted the cotter pin to the stock. I cut and filed the pin down on both sides and then painted it with black paint.