do I need anything else

[moulton]

$135 DoubleStar Lower: http://www.coldwarshooters.net/index...products_id=46
$495 Stag Arms 1H upper assmbly http://www.tenpercentfirearms.com/in...&products_id=5
$55 RRA A2 Fixed Buttstock Assembly http://www.tenpercentfirearms.com/in...products_id=82
$65 RRA Lower Parts Kit http://www.tenpercentfirearms.com/in...products_id=95
$25 Bullet Button Mag-Lock Kit http://www.tenpercentfirearms.com/in...roducts_id=265
$21 Bushmaster 5.56mm 10 Round Magazine http://www.tenpercentfirearms.com/in...products_id=29
Total $796

[Okami]

Looks like it will be very nice!
Please post pics when you're finished!!!

~Okami

[James R.]

$135 DoubleStar Lower: http://www.coldwarshooters.net/index...products_id=46
$495 Stag Arms 1H upper assmbly http://www.tenpercentfirearms.com/in...&products_id=5
$55 RRA A2 Fixed Buttstock Assembly http://www.tenpercentfirearms.com/in...products_id=82
$65 RRA Lower Parts Kit http://www.tenpercentfirearms.com/in...products_id=95
$25 Bullet Button Mag-Lock Kit http://www.tenpercentfirearms.com/in...roducts_id=265
$21 Bushmaster 5.56mm 10 Round Magazine http://www.tenpercentfirearms.com/in...products_id=29
Total $796

Nope that looks like everything, however if you don't already have the lower why not get a matching STAG for your upper?

I have both Stag & DoubleStar, they're both nice don't get me wrong. However, unless your DoubleStar is the variety cranked out by JVP (there are two makers IIRC for DoubleStar) the finish is quite different from what Stag puts on their uppers. Stag lower with Stag upper fits together tight as a glove, it's really nice.

My DoubleStar lower mated with a DPMS upper has a bit of the old wiggle and jiggle. Once I toss that Bullet Button on that thing I think I'll get one of those JP expanding rear take down pins or I'll toss in one of those red rubber deals, I've got a few laying around here...accuwedge.

Regards,

James R.

[moulton]

it was the cheapest lower I could find at the time, but I'll end up getting the stag instead. I like the carbine upper but I absolutely hate the 6 position stock....... I guess that I now know how much it will cost I'll have to get a job and save up some cash (poor teenager)

[rips31]

yea...the most important thing:

ammo

[NextTimeAround]

That's everything. Have fun with your new toy!

[Prc329]

Stag on stag from my experience is a very tight fit. In a fixed mag it may be to tight. In my case it doesn't matter since it is in a griplesss configuration. I would not be very happy if I had to pull my hammer and punch everytime I needed to load my gun.