Converting a Raddlocked V94 and Tavor to featureless

[zrunr]

I am trying to convert my Raddlocked HK94 clone to being featureless. This one has a paddle release that does not work. What parts are needed to make the magazine release operational other than the push button, roll pin, and spring? Is a semi-auto paddle bushing pin also needed? Is this vendor a good source for these parts?

https://www.robertrtg.com/store/pc/Mag-Catch-Assembly-c180.htm

Regarding the Tavor, is there a way to attach something to the stock to increase the overall length to over 30 inches while not changing the LOP such as the plate that flips up on an M14 stock? The typical approach is to extend the barrel length with a threaded adapter, but it would need to be permanently attached to the barrel.

[Quiet]

Regarding the Tavor, is there a way to attach something to the stock to increase the overall length to over 30 inches while not changing the LOP such as the plate that flips up on an M14 stock? The typical approach is to extend the barrel length with a threaded adapter, but it would need to be permanently attached to the barrel.

Nope.

Also regarding the hinged buttplate on the M14, effective 07-31-2017; unless it is fixed in the open position, the overall length of a rifle is measured with it in the closed position.

CA laws/regulations requires the overall length of a semi-auto centerfire rifle be measured with the rifle in the shortest possible fireable configuration (stock folded/collapsed or if quick detachable, removed) and non-permanently attached muzzle device removed.

[zrunr]

That is true. It would have to be fixed in the open position, which is fine because it doesn?t affect length pull. I could not Find a commercial source for something like that. I would prefer that to having to make a permanent attachment to the muzzle.

[hitdank]

https://hkparts.net/all-parts/hkp-mp5-mp5k-9mm-contact-piece-for-paddle-mag-release/

This is what is needed to connect the paddle release. It looks funny but the part that sticks out is what presses against your current paddle. Also if your trigger pull is a little stiff:

https://hkparts.net/all-parts/hkp-semi-elbow-spring-for-trigger-pack-match-grade/

[hitdank]

Has the mp5 rifle parts been changed out?

[zrunr]

Has the mp5 rifle parts been changed out?

Pretty much. I have the mag release button and roll pin but no contact piece. I cut the Raddlock bushing down to the correct size for a standard bushing but haven?t been able to reinstall the part yet. It should work as a magazine release that way.

The semi-auto bushing and pin were not needed as they were already installed with the flapper.