how have you pinned your butt stock for featureless AR's?

[P.Charm]

I have a vltor stock, has anyone pinned it to be featureless compliant? last choice will be to run a couple of roll pins into the lever and stock. I would like other options.

this is the butt stock i'm trying to pin.

https://www.vltor.com/shop/ar/stocks/imod-improved-modular-stock/

[NapaPlinker]

https://www.strikeindustries.com/shop/strike-industries-ar-stock-stop.html

Sent from my SM-G960U using Tapatalk

[NapaPlinker]

https://www.strikeindustries.com/sho...tock-stop.html

Sent from my SM-G960U using Tapatalk

Boom.

Sent from my SM-G960U using Tapatalk

[P.Charm]

hell yeah my brother. thanks.

[baranski]

https://www.strikeindustries.com/sho...tock-stop.html

Sent from my SM-G960U using Tapatalk

Yup!

[Rob323]

https://www.strikeindustries.com/sho...tock-stop.html

Sent from my SM-G960U using Tapatalk

This^^^

[Featureless]

Here's the way to do it.

https://www.bande3d.com/

[NapaPlinker]

hell yeah my brother. thanks.

Cheapest way to. Vs some guys using nuts and bolts. [emoji1785]

Sent from my SM-G960U using Tapatalk

[Ros_sco]

This one worked perfectly on my Vltor EMod

https://www.aimsportsinc.com/m4-stock-lock-pin/

[edgerly779]

a 5 cent rivet from harbor freight.

[ar15barrels]

I have a vltor stock, has anyone pinned it to be featureless compliant? last choice will be to run a couple of roll pins into the lever and stock. I would like other options.

this is the butt stock i'm trying to pin.
https://www.vltor.com/shop/ar/stocks...modular-stock/

Rather than cross pinning, I have been fixing the release lever with a screw so that the lever can not be manipulated without removing the screw (using tools).

[P.Charm]

This one worked perfectly on my Vltor EMod

https://www.aimsportsinc.com/m4-stock-lock-pin/

so you basically remove the lever and when you get to a postion you want you loosen the screw to send the plunger down?

[Scotty]

On one rifle, I'm running full extension, I 3D printed a spacer that is just a slight interference fit and pushed it into the stock. It would take some time and heat to push it back out.

On another one where I run it almost full collapse, I put a small spacer inside the Magpul plunger and also removed the lever and cross pin.

[Oldmandan]

I use the aimsport also

[Ros_sco]

so you basically remove the lever and when you get to a postion you want you loosen the screw to send the plunger down?

Remove the lever, spring and plunger and replace with the stop and bolt. The photo attached is what you take out and the card that comes with it showing how to install. I left the lever off though.