Scar 17 Variances?

[Sicarius]

The radlock is designed to be convertible. It replaces the hammer pin and the wedge and cover are meant to unscrew when you go visit America. You may be missing the original hammer pin but it’s no biggie. It takes 30 seconds to bring to its original glory. Raddlock makes a stock block that will prevent the hinge from opening. You can also pop the pin and put a dowel behind the button. For the telescoping portion, I heard a lego was the right size to prevent it from functioning.
Kevin

[jcwatchdog]

Looks like these guys are no longer in business.

Any other great options outside of the normal wrap?

http://www.exilemachine.net/Backfin.html

You can still find the exile machine back fins around, but the miad grip has to be modified for the Scar lower. You can modify yourself or you can buy it already modified

http://www.parkermountainmachine.com/store/c31/PMM_SCAR_Modified_Grips..html

[Marlin4570]

Right on guys! Found the fin on Amazon and got the PM modified grip.

Should be good to go!

As for the raddlock. It's turning out to not be so simple unless I'm missing something very basic...or just an idiot lol..

The plate comes off easy enough. At that point the rolling pin is flush. On the other side when I try and unscrew it I have a small problem because the entire rolling pin spins. So the screw won't separate. I don't have anything small enough to grab the pin and hold it from spinning. I'll figure it out.

But once it's out, the existing raddlock rolling pin will just stay in place? The original was not screwed in or secured on either side?

[BayMaverick]

Oh, and get an angled charging handle yesterday.

[Marlin4570]

Looks like there are a few options.

1. GGG 30$
2. Apex 50$
3. Kinetic 50$ - I'm leaning towards this one.

Thoughts anyone? I know there is a lot of info out there on these but figured I'd ask...

[jdben92883]

The Raddlock replaced some parts. Don't remember what...been too long since I messed with mine. There was briefly an issue at one point with people buying them new, the seller not including the OEM parts, and FN unwilling to sell the OEM parts to CA. I don't think that's true anymore. In any case, you do need an OEM part or two.

Right on guys! Found the fin on Amazon and got the PM modified grip.

Should be good to go!

As for the raddlock. It's turning out to not be so simple unless I'm missing something very basic...or just an idiot lol..

The plate comes off easy enough. At that point the rolling pin is flush. On the other side when I try and unscrew it I have a small problem because the entire rolling pin spins. So the screw won't separate. I don't have anything small enough to grab the pin and hold it from spinning. I'll figure it out.

But once it's out, the existing raddlock rolling pin will just stay in place? The original was not screwed in or secured on either side?

[tradecraft]

You'll need to purchase an OEM hammer pin.

Get an EACH ch.

[Marlin4570]

You'll need to purchase an OEM hammer pin.

Get an EACH ch.

I bought this.

http://www.parkermountainmachine.com/store/p77/PMM_SCAR_16%2F17_Oversized_Magazine_Release_Button.html

It says it comes with this:

"New 2mm Roll pin included"

I figured I would be covered, what do you guys think?