Magpul HK 91/PTR 91 ambi safety is shipping!

[LEAD LAUNCHER]

I'll take one of these too:

mag1070_blk_01_1.jpg

[NATEWA]

Order placed!

https://magpul.com/what-s-new/magpulesk-magpulslgripmodule-hkpolymertrigger.html

[LEAD LAUNCHER]

Thanks for the heads up NATEWA!

I will order.

[NATEWA]

Got mine today. Will install tomorrow and report back.

[Scratch705]

Does it fit all the clones?

[LEAD LAUNCHER]

Got mine today. Will install tomorrow and report back.

Natewa-have you installed yet?

I've been lazy... selector kit is sitting right next to me!

Ok..will install on the PTR shortly and post review/pics.

Here's mine uninstalled:

[Scratch705]

I just want to know if it will fit zenith clone.

Cause I would buy the selector and the grip module instantly.

[SloChicken]

O

I just want to know if it will fit zenith clone.

Cause I would buy the selector and the grip module instantly.

I pit it on a hk steel lower and it is a little wide.
Had to bend the detent spring so it had a bit more purchase (easy) and it also will/canget stuck above safety on the rotation as the lug hangs up if the left side moves inboard. However, when the upper is on the upper width limits hyper rotation above the safe detent.

All in all a great setup, albeit in plastic, I would really prefer a steel one on my HK.

It will fit polymer lowers just fine I would think as they are a little wider.

[NATEWA]

Natewa-have you installed yet?

I've been lazy... selector kit is sitting right next to me!

Ok..will install on the PTR shortly and post review/pics.

Here's mine uninstalled:

Sorry, I have not. Been busy but will install tomorrow and report back.

[NATEWA]

Installed just now. Very simple. Took 1 minute to install. Flipped from F to S a dozen times. Assembled and tested. No problems. This is a must if you have a fin gripped PTR.

Edit - PTR polymer lower.

[NATEWA]

Does it fit all the clones?

https://magpul.com/media/wysiwyg/MAG1070_Warning_Card.jpg