I guess you could take off the A2 flash hider and just leave it bare.
Or
If it is a little loose, just crimp it a bit.
Since it is copper, the hardened steel from the threads will cut right into the copper.
If you have 10 rifles that need to be brought into compliance, but want to buy good compensators, this will protect the threads until you can afford to buy what you want later.
Use a pipe cutter to trim it a bit. Prime and BBQ paint if you are so inclined.
Or
If it is a little loose, just crimp it a bit.
Since it is copper, the hardened steel from the threads will cut right into the copper.
If you have 10 rifles that need to be brought into compliance, but want to buy good compensators, this will protect the threads until you can afford to buy what you want later.
Use a pipe cutter to trim it a bit. Prime and BBQ paint if you are so inclined.



NRA Benefactor Member
Comment