.510DTC blueprint...

[JPglee1]

JP

[Hanniballs]

and?.........

[JPglee1]

If someone wants to build a .510DTC, there's the specs for the brass and chamber.


JP

[Hunter]

If someone wants to build a .510DTC, there's the specs for the brass and chamber.


JP

Actually they would just call Dave Mansen or JGS for their reamer. Both outfits make them. For a rifle builder to have the dimensions is nice, but not needed, unless they are the one cutting the reamer.

For the dies, same thing. Call the manufacture who has them such as CH4D.

[JPglee1]

Actually they would just call Dave Mansen or JGS for their reamer. Both outfits make them. For a rifle builder to have the dimensions is nice, but not needed, unless they are the one cutting the reamer.

Well sorry, I was just thinking it would be helpful to someone.


J

[Hunter]

Well sorry, I was just thinking it would be helpful to someone.


J

Nothing to be sorry about, I was just explaining the way it works. We all are here to learn,

[Hunter]

On a side note, I see this drawing has the corrected shoulder radius noted. The original drawing seem to show a range when it wasn't, just the way it was put on the drawing. That little detail caused a lot of headaches. Look in the footer of the drawing and you will see the correction from 0/0.125 to what is now shown as 0.125.

The EDM guns use the Mansen reamer with 0 radius and JGS reamer uses 0.125, which is the original spec from DAN TEC, the designer.