Disabling Zhukov Folder for CA

[diesel]

Has anyone pinned or tried to pin the Zhukov folding stock so that it can't fold - until someone come up with a better muzzle break or whatever? That way there's no problem with overall length??

Thanks, Matt

[LeadFarmer74]

Go to local hardware store and buy a longer screw for pivot. Then drill into button some portion so it locks and won't depress.

[tonyxcom]

Aint nothing a strategically placed sheet rock screw won't fix.

If the stock can be disassembled by removing the pin in the hinge then its just a matter of disabling the folder button with a dowel in a round spring or some other block that disables the button.

[Staticsouls]

Small hole and a roll pin into some portion of the stock should work nicely.

[Darthbauer]

I did it without drilling into the button at all. All you need is 1 wooden tooth pic. Take off button, break tooth pic into two pieces that are the same length as the springs. Insert tooth pics into springs, reinsert the springs back into the button and put the button back into the stock. Cheap and works. I used the same method on the ACR folding stock with a wooden dowel.

[diesel]

Right on, thanks for the input. I guess I'll just have to order one and go from there... I was planning on just going MOE, but the Zhukov looks so good!



NICE!! That's the route I'm going Darthbauer, thanks!

[saki302]

I've done two.

Simply drill a small hole in the bottom where the button is, and install a sheet metal screw.

It's not some weird rare (or expensive) factory stock, so my friends weren't picky about the little hole left underneath.

-Dave

[DAZE752]

The size is in between 1/2"-3/4" in length fully locks the button


Sent from my iPhone using Tapatalk

[RobGR]

I did it without drilling into the button at all. All you need is 1 wooden tooth pic. Take off button, break tooth pic into two pieces that are the same length as the springs. Insert tooth pics into springs, reinsert the springs back into the button and put the button back into the stock. Cheap and works. I used the same method on the ACR folding stock with a wooden dowel.

Bravo! I like it.

[REDdawn6]

I did it without drilling into the button at all. All you need is 1 wooden tooth pic. Take off button, break tooth pic into two pieces that are the same length as the springs. Insert tooth pics into springs, reinsert the springs back into the button and put the button back into the stock. Cheap and works. I used the same method on the ACR folding stock with a wooden dowel.

MacGyver award for genius!!

[Crazygoonie]

Ammo Bros in riverside had one today already pinned 90 bucks

[eMerG636]

Has anyone figure out how to pin a zhukov stock for a yugo?

[AKSOG]

Has anyone figure out how to pin a zhukov stock for a yugo?

I don't think it will be any different on a Yugo than whats been posted already

[eMerG636]

Ahh ok, wasn't sure thanks.

Sent from my SAMSUNG-SM-G920A using Tapatalk

[Ducckk]

[/URL]

I know this was a while ago, but how did you actually remove the button? I have this stock, but I cannot find out how you pulled the button off.