Assembling AR

[cgseanp1]

So I finally have all my parts, can someone point me in the right direction to get this thing put together? I figure there is a write up somewhere, I just can't find it.
Thanks

Sorry, just realized there is a how to section.. I don't know how I missed that.

[aplinker]

Always look here first:

http://www.calguns.net/calgunforum/showthread.php?t=56818

there are about 10 links on lower assembly (photos, how-tos, pdfs, videos)

[Darklyte27]

right in front of your face!!!

http://www.calguns.net/OLL/assembly.html

[cgseanp1]

Thanks.. I knew it would end up being right in front of my face...

[EOD3]

If you go to the Brownells website, there are videos of each assembly step... Very well done and a picture is worth a thousand words, a video is the whole book.

[optimus-primer]

If you go to the Brownells website, there are videos of each assembly step... Very well done and a picture is worth a thousand words, a video is the whole book.

+1!

[cgseanp1]

Hmm.. soo according to brownells, I need about 100 different tools to put together the lower, and unfortunately, the only one I think I have is the screw driver!

[naimad]

http://www.ar15.com/content/guides/assembly/lower/

[domokun]

Where are you located?

[domokun]

Hmm.. soo according to brownells, I need about 100 different tools to put together the lower, and unfortunately, the only one I think I have is the screw driver!

Where are you located?

[cgseanp1]

Where are you located?

san diego. I'll add that to my profile.

[1BigPea]

If you go to the Brownells website, there are videos of each assembly step... Very well done and a picture is worth a thousand words, a video is the whole book.

Yah, those videos are good, you don't need all those tools, are you just assembling a lower?

Check out the AR15.com website, someone else posted a link to the directions there too.

[Blwnbwtie]

http://www.lifelibertyetc.com/RangeBag/video/LLE_AR15StrippedLower.wmv

this is also a pretty good video showing you how to assemble a lower with farily minimal tools.

[Yargh]

I just put together my first lower tonight and did the whole thing with only two tools, needle nose pliers and a screw driver that can switch between a flat head and a hex.

I used the guide at AR15.com and it only took about 45min and bloody thumb to finish it! (damn bolt catch roll pin)

[1BigPea]

http://www.lifelibertyetc.com/RangeB...ippedLower.wmv

this is also a pretty good video showing you how to assemble a lower with farily minimal tools.

Ahh...yes. I was looking for that too, couldn't remember where it was. That was the original one I watched.