Trigger guard removal

[AdamM]

I decided to install enhanced trigger guard that is part of the front strap for my MIAD and am having trouble removing the roll pin from the old one. Any suggestions? I tried a roll pin punch- doesnt budge. Any ideas on how to remove this?

[jandmtv]

Try spraying some WD40 on both sides and let it soak in and hammer away with a punch. Do put some support under the tab so it doesn't break.

[5150Marcelo]

take another gun and shoot it off!

[AdamM]

Try spraying some WD40 on both sides and let it soak in and hammer away with a punch. Do put some support under the tab so it doesn't break.

I tried that too
I just dont want to break the tabs or anything so im trying to be careful

Ill try it again though since its been sitting. Maybe the WD40 soaked through more

[AdamM]

take another gun and shoot it off!

LOL! Not when a new lower is like $550 and impossible to find! haha

[5150Marcelo]

LOL! Not when a new lower is like $550 and impossible to find! haha

[jandmtv]

Take a 2x4, wrap it with 2-3 layers of electrical tape, and put it under the tab for support, and give it a good wack to break it free.

[AdamM]

Take a 2x4, wrap it with 2-3 layers of electrical tape, and put it under the tab for support, and give it a good wack to break it free.

Alright, Im gonna go try that. Ill be back in a bit and let you know how it goes

[AdamM]

I got it out! lol, man, that thing was in there tight. Just changing it to the new one makes it more comfortable. That gap between the PG and the trigger guard started hurting after shooting for awhile. Glad its gone