bcm 14.5 mid using A2 stock / buffer assembly

[Cadre]

Hey bruthas,

Just got myself a middy bcm 14.5 I want to pair it up with a lower the has an A2 stock.
I did some searches with mixed feed back. Some guys said it will have problem some say it will be fine.

Do you guys see a problem with that get up if so what would you recommend.

Thanks in advance

[fmunk]

You should be able to use a carbine buffer + spacer, like Spike's T2 buffer and spacer.

[AreWeFree]

Not sure I'm understanding, are you concerned that it wont function with a rifle buffer and spring?

I believe even with the 14.5" barrel and mid length gas, you still have higher pressure than a 20" barrel with rifle length gas system.

Just FYI, I run a 14.5 mid length with H2 buffer and extra strong carbine spring without issue. Comparatively it's similar to a basic rifle buffer/spring.

Edit: See for yourself: http://ar15barrels.com/prod/operation.shtml

[Cadre]

thanks. sounds like it should be fine.

[MrPlink]

With 5.56 it should probably be fine.
Might get finicky with some of the cooler .223 loads, esp the imported steel case stuff.

[Cadre]

With 5.56 it should probably be fine.
Might get finicky with some of the cooler .223 loads, esp the imported steel case stuff.

thank you sir.

[vintagearms]

I used to run that same combo with wolf ammo and it ran fine.

[RAMCHARGER]

Works fine for me. It does dump the brass next to me rather than launch it two lanes down.

[Cummins_Powered]

Not quite a 14.5 but my dissipator(16" barrel) has an A2 stock and a midlength gas system. Runs flawlessly. You should be able to tweak just about any configuration of gas length and buffer system to run properly