The 80% adventure begins.

[Germz]

[boludo12]

Take your time. I just finished an 80% and loved it. Did a poly lower first and discovered a few no nos with it.

[BigPimping]

Let me take a few and I will update this thread!!!!!

[ThighSlapper]

Let me take a few and I will update this thread!!!!!

If your done with the Jig lemme know how much youd like for it Big P!

[fivecardarmy]

Used Jigs Please

How come everyone buys new jigs? Can't they be used over and over again? The jigs costing more than the 80%ers seems weird. Any thoughts, I've searched for used jigs and came up short. Newb doing finally doing my duty as an American. Rights that aren't used are losed.

[CK_32]

Good luck man!


All I gatta say, is get ready to hold on for your life when milling lol

It's an awesome adventure. I took the plunge 4 times. First 2 were sketch and a ton of lessons learned.

Take your time, measure 100 times cut twice.

[jwilson.redding]

How come everyone buys new jigs? Can't they be used over and over again? The jigs costing more than the 80%ers seems weird. Any thoughts, I've searched for used jigs and came up short. Newb doing finally doing my duty as an American. Rights that aren't used are losed.

I did 5 lowers with the same ez jig, and it looks ready to do 10 more, my router bit is near done though.

[bohoki]

make sure you debur the safety detent pin hole also use a file to connect your holes for the trigger slot if you drill 2 holes then try to drill one in the center it will end up looking like a kidney bean