Rem 700 thread barrel.

[AlexZ1742]

Hello everyone im in a little problem here I have a Remington 700 sps varmint and want to thread the barrel but I have been doing some googling and came up with nothing. I was wondering if someone can refer me to a gunsmith that will thread the barrel and not too far from the San Fernando Valley.
Thanks Again.

[baih777]

if you scroll down a little further you would have seen this thread.

http://www.calguns.net/calgunforum/showthread.php?t=926955

[AlexZ1742]

I guess I miss that one thank you baih777

[jpx0123]

Randall from AR15barrels should be able to do it. he is in thousand oaks area I think.

[CSACANNONEER]

AR15Barrels is in Van Nuys.

Addax is in San Fernando.

Sinister Arms is in Thousand Oaks.

Any of these three will do good work.

[emy]

contact AR15 Barrel , you might even be able to wait for it

[AlexZ1742]

I checked out Addax and they told me they dont have all the necessary things so I will check ar15 barrel. Has any one tried the JP enterprise comp?

[baih777]

I really like the JP comp. My friends hate it. It does make your rifle louder. But it does not bother me. Measure the diameter of your barrel. They come in different diameters . Randall can time the comp.

[vintagearms]

+1 for Sinister Arms. He has done custom work to my Remington 700 including threading the barrel for a Vais MB. Now, I just have to get over my surgery to take it for a spin.

[ar15barrels]

I thread barrels on 700's and time muzzle brakes while you wait.
Just pm me to setup an appointment after you have the brake in-hand.

[AlexZ1742]

If you guys dont mind me asking what does timing a brake mean?

[strongpoint]

If you guys dont mind me asking what does timing a brake mean?

simple answer: it means installing the brake so that the top faces straight up and the side ports are level.

[baih777]

You can install the brake with or without (the back of the brake may need to be machined) the washer.
If you go to Randall take the brake with you.

[AlexZ1742]

Ok sounds good thanks guys.