Unconfigured Ad Widget

Collapse

Request for Marlin 336 pic

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Bainter1212
    Calguns Addict
    • Feb 2013
    • 5936

    Request for Marlin 336 pic

    Hello all,

    I am putting a new loading gate on my 336 (the old one broke) and it needs a little bit of fitting.

    Can somebody snap a close-up pic of their properly fitted loading gate?

    Thanks in advance. Cheers!
  • #2
    otteray
    Veteran Member
    • Feb 2006
    • 3250

    Not sure what you want. but here's a photos online.
    You can zoom in on this photo from Cabelas:
    336
    sigpic
    Single fin mentality

    Comment

    • #3
      Bainter1212
      Calguns Addict
      • Feb 2013
      • 5936

      Originally posted by otteray
      Not sure what you want. but here's a photos online.
      You can zoom in on this photo from Cabelas:
      336
      Doesnt really help but thanks anyway

      Comment

      • #4
        otteray
        Veteran Member
        • Feb 2006
        • 3250

        did you try asking any of the levergun forums? Like, Marlinowners.com or else http://www.levergunscommunity.com/
        sigpic
        Single fin mentality

        Comment

        • #5
          Pofoo
          Senior Member
          • Dec 2009
          • 1693

          Well, since you're not getting much help, I'll give my $.02.
          Compare your new part to the old part, and if they're different, then you might have the wrong part. Are there different part #'s for different models or calibers?
          A correct, standard replacement part should fit flush with the receiver with minimal, but necessary, clearances.
          It's kind of like nuts and bolts. If you buy the correct nut, it should fit the correct bolt. If not, something is out of spec., and it would probably be better/easier to buy the right one. This is not a antique rifle that you should have to modify parts for.
          Perhaps the gun smithing section would get additional comments.

          Comment

          • #6
            Bainter1212
            Calguns Addict
            • Feb 2013
            • 5936

            Thanks everyone

            Comment

            • #7
              Hairball
              Senior Member
              • May 2013
              • 799

              You can PM me your number and I can text you a pic of mine...

              Comment

              • #8
                Bainter1212
                Calguns Addict
                • Feb 2013
                • 5936

                Originally posted by Hairball
                You can PM me your number and I can text you a pic of mine...
                Pm sent

                Comment

                • #9
                  SBsasquatch
                  Senior Member
                  • Jan 2013
                  • 828



                  OOPS WRONG ONE!!!




                  Last edited by SBsasquatch; 01-21-2017, 9:29 PM.

                  Comment

                  • #10
                    Bainter1212
                    Calguns Addict
                    • Feb 2013
                    • 5936

                    Thanks all. Looks like I did it right.

                    My old one broke. The new one (a factory Marlin part) didn't quite fit perfectly, I had to take a bit off of one edge.

                    Comment

                    Working...
                    UA-8071174-1