Flush Cups

[signal5delta]

I live in the San Francisco Bay Area and I have a remington 700 in a Bell & Carlson A2 stock. Do any of you know of anyone who would install flush cups on my rifle? Thanks.
Jim

[Dano3467]

Probably sounds stupid, but what are flush cups OP. Idk

[LynnJr]

Jim Ketchum in Petaluma will do them 707-762-3014
Tell him Lynn says hello.

[TruEdge]

Probably sounds stupid, but what are flush cups OP. Idk

Basically a spot to attach a swivel sling. There's a lot of info out there online to help you do it yourself OP.

[SilentPea]

$10 amazon tap 9/16x18 (you might want to double check that thread size)
$10 grovtec flush cup I like the limited rotation type
1/2" drill bit (you probably already have this)

Some locktite or epoxy, and you're good to go.

[supertrooper]

$10 amazon tap 9/16x18 (you might want to double check that thread size)
$10 grovtec flush cup I like the limited rotation type
1/2" drill bit (you probably already have this)

Some locktite or epoxy, and you're good to go.

+1. They are easy to install yourself if you have a drill.

[FourT6and2]

Try Spartan Precision in San Jose? I don't know if he does stock work though. Give 'em a call.

[NorCalFocus]

$10 amazon tap 9/16x18 (you might want to double check that thread size)
$10 grovtec flush cup I like the limited rotation type
1/2" drill bit (you probably already have this)

Some locktite or epoxy, and you're good to go.

+1. They are easy to install yourself if you have a drill.

Easier if you have a drill press.

After drilling the 1/2" hole, you chuck the tap and turn the press by hand to run the tap into the hole. That way your tap runs straight down the hole.

[sealocan]

What are flush cups?



the thing that was invented before the three seashells came along.