G19 Build

[omalley72]

Just finished my Gen 3 G19 build. Looking forward to getting out to the range tomorrow to run some rounds through it.

Framework - Project 1 Design
Slide - Strike Industries ARK
Slide Internals - Shadow Systems
Barrel - Strike Industries ARK
Trigger - Apex
Magwell - Suarez International
Sights - Strike Industries Modular Blade Sights
Optic - Vortex Viper
Extras - Strike Industries Base Plate
Strike Industries Pin Set
Strike Industries Back Plate

[Blauplow]

That looks beastly

[Old Flash]

Very nice build OP! Let us know how it shoots.

[ZX9ALLDAY]

Sexxy! Let us know how that slide runs!! I really like that look

[alx_cee137]

Very nice sir! I am looking at the same magwell, but it says on the site that it might or might not work with the OEM 10rd mags. I have three of them and two magpuls, only asking because I noticed that the SI baseplate on your mag and want to know if you're running 10rd OEM or screw driver on "high cap" lol.

[omalley72]

Very nice sir! I am looking at the same magwell, but it says on the site that it might or might not work with the OEM 10rd mags. I have three of them and two magpuls, only asking because I noticed that the SI baseplate on your mag and want to know if you're running 10rd OEM or screw driver on "high cap" lol.

I didn't have any issues with it working with an OEM 10rd mag. In the past, I used one of their magwells and I did have issues with it working with OEM 10 rounders, but not with this magwell - hope that makes sense

[Transient]

That's a good looking gun. Not a fan of the stippling, but the rest of it looks great. I recently started to discover Strike Industries, too. I have a few pieces on my AR-10 that I'm currently building (remember, I'm not in CA). I'm currently sitting on 2 G19 frames that need building; gen 3 and gen 4. I might have to use one of them to copy what you did (but go with a different stippling, lol). Well done. Please post up how it shoots.

Sent from my SM-N960U using Tapatalk

[ReidT]

Gnarly looking gun!

[Powder_Keg]

Well done, I like it!

[DangerClose814]

Nice looking gun, who did the stipple work on it?

[223556]

(Thumbs up) looks awesome. Been debating getting their slide, barrel, and mass driver comp.

[101st Airborne]

Very nice.

[Old Flash]

Great looking build!

[SR514]

Nicee!!!

[omalley72]

I appreciate the comments!