Tweet
Hey guys
Noob to Glocks, just completed a Spectre 80 with an OEM build kit from Jsdsupply.
Everything went together well and functionality check a+.
Here's the problem...
Using OEM glock mags, after 13 rounds, my mag release carved the lip on mag where it sits on release so that it fell out after every shot. Switched mags ( 2nd oem glock mag ) and was able to run 37 rounds without a hiccup but... I can see stress to the lip of mag that sits on the mag realese.
I feel like I will chew up mag after mag in which the top of the cut out on the mag that locks in place will eventually not catch on the mag release.
Any ideas will be welcome.
Thanks in advance.
Noob to Glocks, just completed a Spectre 80 with an OEM build kit from Jsdsupply.
Everything went together well and functionality check a+.
Here's the problem...
Using OEM glock mags, after 13 rounds, my mag release carved the lip on mag where it sits on release so that it fell out after every shot. Switched mags ( 2nd oem glock mag ) and was able to run 37 rounds without a hiccup but... I can see stress to the lip of mag that sits on the mag realese.
I feel like I will chew up mag after mag in which the top of the cut out on the mag that locks in place will eventually not catch on the mag release.
Any ideas will be welcome.
Thanks in advance.
Comment