Glock question

[Dumas1012]

I installed a ghost connector on my Glock and noticed that the action is not clean. It would catch right at the end when the slide is racked. This is my third Glock and I've never noticed this on the other two (been sold). I did put on the factory connector and it still does the same thing.

OCD or not normal?

[oath-keeper]

Looks fine to me, rack the thing, you won't hurt it, pull all the way back let it slam home..

[killmime1234]

That happens to my g23. It became almost entirely unnoticeable after I hit it with some lube.

[utc]

Ocd

[axhoaxho]

It looks fine to me. If it shoots fine, then no worry.

[ColtShooter]

Sling shot it and let er ride!

[MontClaire]

I installed ghost connector too along with springs ( striker, trigger, extractor plunger). My G19 racks and operates just like it was before the install. In fact I doubt anything has changed since the factory state. I never had anything like what you're experiencing.

[gwhiz]

Depends on the Ghost. I found the new-ish EVO connector to drag pretty noticeably. Older style did not. Switched to OEM minus now.

[tonyxcom]

Shoot it. You might find that your trigger doesn't reset in which case toss the ghost connector in the garbage and get the minus connector from Glock

[BigL]

Same thing happens on my g26 but not my g19 it cycles just fine when at the range so no worries. Just make sure your fully in battery if you plan on carrying it.

[WizeWizard]

Glock. Perfection. Well almost.

[BigPimping]

There is no substitute.

[Dumas1012]

Just got back from the LGS and they said the ejector was slightly bent. I went ahead and purchased the $9 dollar part. Although the new one helped, it still snags a little. I'm just gonna go and shoot it. It's just a Glock.

[1911R SSS]

Wow that thing sounds Smooth.