Kydex custom p07 holster

[Click Boom]

The last two are me trying to take a pic of myself with it in the 1 o'clock and 4 o'clock positions. It was an awkward angle to hold the camera at, haha. That higher back makes it more comfortable against the body, and makes reholstering easier. Fully adjustable for cant with the clip.
Very comfortable and discreet overall. Doesn't print with a t-shirt: (t-shirt is hanging a little funny because I'm holding my arms up to take the pic):

I like it. The p07 lends itself pretty well to carry because of the slim design.
I like the holster a lot. It's cool that you can switch it to OWB by unscrewing it and putting the clip on the other side.

[pastureofmuppets]

If you do another and you want better definition and a "click" in retention it may be a case of heating the Kydex more... looks like 0,080 which likes 320 - 340 degrees and black can go nearer 360 before going shiny if you're careful... more pressure on the press as well.

The edges look a bit rough... but it could be the light. If they are and you don't have access to a belt sander, you might enjoy the results of 150 grit paper, then 220 then 500 sanding by hand with some water.

The P07 has big 'ol decocker and releases... a pain to block out I know. CZ's drive me nuts to prepare for molding!

[Click Boom]

It has a very positive click retention.

[Click Boom]

To make the part for the decocker I just tape up spaghetti Against it haha