Help, I'm retarded. (Glock problem)

[gotime]

Ok so I'm bored as hell and I decided for some stupid reason to try and put my Glock 35 barrel into my Glock 27. I stuck the spring from the 27 on the 35 barrel and slid it on to my 27 frame. It's now stuck.

I've tried zip-tying the trigger back, holding the take down tabs and pushing the slide against my desk with no avail. I can't tell for sure if the problem is the barrel not clearing the take down bar (term?), but I am holding the tabs completely down when I push forward on the slide. Any suggestions?

Yes, I have my flame suit on.

[rkt88edmo]

lol - not familiar with the subcompacts, hope you get some useful advice other than to use a bigger hammer.

[faris1984]

Pics?

[gotime]

I'll get a pic up first thing in the morning. I'm thinking its the barrel not clearing the take down bar completely.

[Oliver_Charles]

***

[NikePenguin]

Did you decock it?

[vintagearms]

Remove the rear slide cover plate and disassemble. Once you remove the parts there, try to pull the slide lock down as you try to remove the slide. It may take a bit of work but it should come apart.

[ShooterStymie]

So that's what Glock owners do with their guns...

Just kidding. Hope you're able to get it solved and save both guns.

[digdug74]

I see this ending badly...

[Glocked@45]

PM if you can not figure it out. Not sure where in the IE you are, maybe I can help. This is something I have not seen or done before but I am sure its
fixable don't stress too much about it.

[dyson]

Get some lube?

[charlie999]

try remove the firing pin and then try again

[SonofWWIIDI]

Bigger hammer!

[kel-tec-innovations]

Keep racking it back and forward, it'll come off. Make sure its decocked and hold down the slide release(not the magazine one ). If it doesn't work, pull forward while slide release (not the magazine one) then pull the trigger and try wiggling all at the same time.

[ArmedCMT]

Remove the rear slide cover plate and disassemble. Once you remove the parts there, try to pull the slide lock down as you try to remove the slide. It may take a bit of work but it should come apart.

^^^This.

I didnt want to post about this when I did it but I guess Ill share. A few weeks ago I tried to put my G35 slide on my G23 frame Did not go well. My first reaction was to post but then I took a breath and went to Google and Youtube. After about 5min of looking and another 5-10min of disassembling while trying not to break anything it finally came apart.

Good luck