Help with pistol reassembly

[lugee]

This may be a really dumb question. I Don't know why but I have been having problems reassembly my Sig P6 since day one. The Barrel doesn't seem to fit correctly. I know on most P6's the barrel almost sits flush against the top of the ejection port and firing pin housing.

I am just trying to figure this out so I can shoot this damn thing again!

Thanks!

-Louis

[QuarterBoreGunner]

Did you remove the locking insert from the frame?

[69Mach1]

Yep, flush. Do you have a pic of what yours looks like?

[lugee]

Thats how mine sits.

[QuarterBoreGunner]

Oooookay... is that picture with the recoil spring assembly in place?

[lugee]

Did you remove the locking insert from the frame?

The take down lever? (I think thats what its called) It swivels down revealing a flat spot to pull the slide out. The feed ramps on the barrel are getting stuck on the frame before sliding into place because it sits a good 2 - 3 mm's lower.

[lugee]

Oooookay... is that picture with the recoil spring assembly in place?

yes.

[The SoCal Gunner]

Was it fine when you first bought it since you say 'shoot this damn thing again'? If yes, then maybe you just didn't reinstall it correctly.

[lugee]

Was it fine when you first bought it since you say 'shoot this damn thing again'? If yes, then maybe you just didn't reinstall it correctly.

It has been a reoccurring problem over and over again. I took the whole slide apart and put it back together to make sure it fits fine, but that didn't work. Everytime i take it apart this happens =(

[QuarterBoreGunner]

Ah yeah I can see that now from the picture..

dammit know I need to go get mine from the safe and see what's what.

[lugee]

I think its the chamber section of the barrel. That part seems to not fit correctly.

[Slayer]

This may be a really dumb question. I Don't know why but I have been having problems reassembly my Sig P6 since day one. The Barrel doesn't seem to fit correctly. I know on most P6's the barrel almost sits flush against the top of the ejection port and firing pin housing.

I am just trying to figure this out so I can shoot this damn thing again!

Thanks!

-Louis

Throw it away, buy an M&P.

[QuarterBoreGunner]

I think its the chamber section of the barrel. That part seems to not fit correctly.

Nein! Tuetonic engineering control would not allow such a thing to leave the factory.

Seriously it's probably something really simple.
I just don't know what.

[lugee]

Nein! Tuetonic engineering control would not allow such a thing to leave the factory.

Seriously it's probably something really simple.
I just don't know what.

haha - At this point i just want to take a hammer to it. I tried to press it in and it seriously doesn't fit.

[pklin1297]

Time to get this:

http://www.topgunsupply.com/Sig-Sauer-Armorers-Course-DVD-P-SERIES-pr-131.html

I've already gone through my AGI Sig Armorer's DVD and I still have reservation so I am getting this. I'm not doing a complete disassembly until I understand it completely...