Glock 21 gen 2 advice please

[cancan221]

What is the best aftermarket parts in your opinion for a glock 21 gen 2 .45 acp???

[cancan221]

Bump

[89 Vision]

What are you trying to do exactly? Glocks are pretty darn good out of the box. Most common mods people do are extended mag release, and extended slide stop. The stock Glock sights are serviceable, but there are better options out there.

[Lead Waster]

I put an aftermarket barrel in mine. That's about it... that was so I could shoot lead bullets way back when lead was a lot cheaper than FMJ.

[G-forceJunkie]

Nothing. Its is fine as is. I take that back, you need to install about 50,000 rounds through it.

[SILENT GUNMAN]

Just put some night sights on it and spend lots of money on ammo. That will hive you the best results. I hate the stock Glock sights.

[Eric B]

Ive had mine for almost 7 years, carry it about 50hrs a week, shoot a minimum of 200 rounds a month and the only thing I've replaced is magazine springs. It needs nothing.

[451040]

better sights of your preference
Vickers slide stop

[The Angry Goat]

Ive had mine for almost 7 years, carry it about 50hrs a week, shoot a minimum of 200 rounds a month and the only thing I've replaced is magazine springs. It needs nothing.

AMEN to this guy!

[billt]

What is the best aftermarket parts in your opinion for a glock 21 gen 2 .45 acp???

None at all. If you look at all of the Glock pistols in use at the various ranges, more often than not, the only one's you'll see having problems are Glocks with aftermarket parts in them. Glock got it right the first time.

[Lead Waster]

None at all. If you look at all of the Glock pistols in use at the various ranges, more often than not, the only one's you'll see having problems are Glocks with aftermarket parts in them. Glock got it right the first time.

Yep. Like I said, I bought an aftermarket barrel. It would not fully return to battery after every shot and required me to push the slide forward. That lead to poor feed reliability. I couldn't figure out where it was touching (Too cheap to use a gunsmith) so I put the stock barrel back in. Years later I figure out that I needed to slim the barrel down just a touch with some sandpaper. But seriously, how precise can you be just wrapping a barrel and spinning it?
But I was convinced that was the only way to safely shoot lead. Now that it fits, that's what I use. However, I've lost love for it as I've aquired other guns since.

Also, until I learned how to properly grip/shoot with two hands (isoceles for me) I complained all the time about the Gen2 G21's massive grip. But with two hands, it's not an issue.

This reminds me that I need to show it some love and bring it to the range with me next time!

[cancan221]

Thank u guys

[xxxx]

Sights and ammo, everything else is junk. /fin