M&P internal lock plug inset.

[Thunder Beast]

The internal lock plug is inset into the frame of the gun. This is preventing the sear block from lifting up and out.

I've taken the sear block out before and know that the plug will normally fall into the frame.

So my question is, how do I proceed? I don't want to inset it further if it won't clear the inside of the frame so that I can lift the sear block. And I don't know how in the world I'd get it backed out.

[Jet Setter]

Hey buddy,

That sucks. Did you slap your friend for screwing things up?

Might work if you do not have an Apex RAM installed - if you push that plug further in, it should pop into the gap of the trigger spring where the RAM would sit. Otherwise, you will need a new plug as you might have to drill it out. Not a gunsmith but just a thought. Don't want to cause you more hassle. Hope someone else will chime in.

[IAMSWUTIAMS]

You need new friends.

[Bug Splat]

I know this may sound crazy but have you tried using a straw and putting a suction on it and pulling it out that way? I've done this a few times on car parts. tell your buddy he owes you a blow job and have him suck it out