Is Jagerwerks Slide Machining Worth the Hype?

[xounlistedxox]

Long had I been a lurker of Jagerwerks website contemplating sending a slide in to have their milling services done. Prices are a little steep, so I've been hesitant. I know they do work on Glocks and some CZ, Sig, S&W, H&K currently.

After getting a botched optic cut from a local shop, I figured I should probably give Jagerwerks (or similar reputable shop) a try.

Initially I was going to just get an optic cut, but I figured since I'm already going through the trouble of shipping it in and waiting I might as well check out their other machining work.

This is the Breacher Slide Pattern, Trijicon RMR cut, Black Nitride with front serrations on the top.

[gil671]

They're good to go. I've had work done from them for my G19 awhile back and they did a good job.

[naz]

+1 on optic cut from a reputable shop. My personal experience has been with primary machine, cgw, czc and chpws

i dont bother with other cosmetic cuts because it’s not my taste but you do you!

[xounlistedxox]

+1 on optic cut from a reputable shop. My personal experience has been with primary machine, cgw, czc and chpws

i dont bother with other cosmetic cuts because it’s not my taste but you do you!

I have two from Jager and also Battle Werx so far. Made the mistake of trusting a local shop with another... no recoil lugs and the optic didn't even fit snug. Won't be doing that again.

For this slide, I prefer to have forward serrations, especially with this big ol optic, the slide windows are somewhat cosmetic, but also save some weight. Important when you're adding a comp that adds a good bit of weight. Most folks that shoot this say that it feels much lighter than it looks, and I agree.

[tacticalcity]

I had a slide milled for an RMR by Wager Machine Works. It turned out great. From what I have read here and elsewhere, others have had the same experience. They are good to go. Pricing was not bad as I remember. Optic Cuts - Wager Machine Works

[el_clingon]

I like jagerwerks. The slide cuts are nice. There are others snipes that are good too but do your homework when picking them. I can say, avoid DYNAMIC WEAPONS (DWS) at all cost. Those mother****ers stoled my slide which they said was lost during shipping then I had to purchase a replacement from them because they would not give me a refund and to this date I haven’t received the slide yet and it has been almost a year now.

Sorry had to vent but Jagerwekr are a stand up company and great products

[enorbit3]

I had a slide milled for an RMR by Wager Machine Works. It turned out great. From what I have read here and elsewhere, others have had the same experience. They are good to go. Pricing was not bad as I remember. Optic Cuts - Wager Machine Works

Another positive for Wager. I wouldn't have minded using Jager but the turnaround time was a bit too long for me, especially since it was one of my CCW pistols. My g19 black nitride slide with RMR cut took a total of 3 wks door to door.

[BEE]

+1 Jagerwerks is GTG if you can withstand the wait.

Had a few slides sent in for RMR cuts and nitride coating and all of which have been perfect. Also I usually wait and buy into their black friday optics cut promotion.