3.5lb connector for Glock

[Raptor3000]

Hi Guys,

Planning to order the following Ghost 3.5lb connector for my Glock 17 Gen 3

http://www.ghostinc.com/product/GHO_3TCFORGLOCK/35-lb-Trigger-CONNECTOR-for-GLOCKS-GENs-1-4.html

What do you guys think about it? any advice/guidance is appreciated.

thanks

[Allentu]

Combine that with a .25 cent trigger job and youre good to go

[watsonville]

Any experience with the glockworx 2lb connector ?I'm probably going to get a 3.5 lb connector also

[MA2]

I have the Ghost on my 19 (no 25 cent polishing), really like it enough to just keep it like that, guess it can be better.
Should net you to close to ~4#.
If you want closer to ~3.5#, I think a NY1 spring is needed.

Lonewolf, Scherer, & Glock also makes a 3.5 connector (Glock renamed theirs to 4.5 now, I think).

Check the ebay, will save you a few bucks over direct from Ghost.

Simple installation drop in for me, have fun =)

[Kenji8]

...

[Kenji8]

...

[scglock]

I have the ghost ultimate connector and just did the 25 cent trigger job recently. Its pretty smooth you'll enjoy it

[223556]

I have one dropped in my G17, love it.
Its a little mushy sometimes though but much better then the stock weight to me.

[NewbieDave]

I installed the 3.5lbs Rocket with an addition of a Wolff comp spring kit upgrade... my trigger is fast, smooth and in the 4lbs range with no over-travel.

The Rocket is the one with the over-travel tabs that you have to fit by filing down the tabs. Worth it IMHO for the quicker reset of the trigger... your follow-up shots are a lot smoother.

[sammy]

The one I got was garbage. It ran for about 2000 rounds then the trigger went dead. Glad it was not a HD gun (then again no mods on any hd gun). Not sure why it failed. It looked perfect. Probably a fluke but if it is a range gun go for it. Much lighter than factory.

[Bill Steele]

I have 3.5 Rocket bars in all my Glocks. I buy the kit that comes with the springs, don't use the light striker spring as I get light strikes, even on the relatively soft Winchester primer cups. I also do the 25 cent trigger job on each of my guns.

If this is your first GR trigger bar upgrade, buy the armorers kit, it comes with a half height slide cap which makes fitting the over travel tab easier. The kit also includes a punch with a plastic handle, making pin removals pretty easy.

There are lots of YouTube videos on how to fit the over travel tab, install the bar and also ones on the 25 cent trigger polishing job.

Good luck, have fun.