Unconfigured Ad Widget

Collapse

M&P45 ftrtb question

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ILVSMOG
    insert clever title here
    CGN Contributor - Lifetime
    • Sep 2009
    • 611

    M&P45 ftrtb question

    I took by new M&P45 to the range this evening to shake it down. I put 250rds of American Eagle (Federal) 230gr FMJ through it and it performed fine, except for 3 failures to return to battery. I wouldn't have worried too much about it, but 2 of them were consecutive. (bang-ftrtb-clear-bang-ftrtb). The pistol never felt like it short-stroked, but I'm hoping that I just got a few under powered loads. I recreated the failure at home for the pictures and all I needed to do was slow the forward slide travel. Any ideas on what else may cause this? Should I worry?
    Attached Files
  • #2
    hayaku
    Senior Member
    • Mar 2011
    • 538

    was the gun oiled?

    Comment

    • #3
      ILVSMOG
      insert clever title here
      CGN Contributor - Lifetime
      • Sep 2009
      • 611

      Yes, it was cleaned and oiled per the manual before firing.

      Comment

      • #4
        brian5271
        Senior Member
        • Jul 2011
        • 637

        Does it do it with both mags or just one? If it is just one, you might have a bad mag that is not seating properly.

        The M&P should not do that and S&W will take care of it for you. The only time my M&P did that is once when I did not seat the mag completly. Other than that, I have close to 8k rounds thru my 45 with no problems.
        If I had to describe myself in one word it would be "bad at following directions"

        Comment

        • #5
          ILVSMOG
          insert clever title here
          CGN Contributor - Lifetime
          • Sep 2009
          • 611

          I just cleaned it and I'm going to try to go to the range again today and put another 100rds or so through it. If it does it again, I may have to call S&W.

          Comment

          • #6
            Clutch-n-Throttle
            Member
            • May 2011
            • 277

            When I owned an M&P45, I had the same FTF. It would happen occasionally.

            A little filing can "fix" the situation.
            CLEVERLY DISGUISED AS A RESPONSIBLE ADULT

            Comment

            • #7
              buggsb
              Member
              • Jan 2006
              • 186

              I took my new M&P 45 out this week and saw the exact same thing....3 times out of 50 rounds. I'll run few more boxes through it before coming to any conclusions.
              ROGUE Specialty Products
              "Rugged Outdoor Gear and Urban Equipment"

              Comment

              • #8
                Sgt. J Beezy
                Banned
                • Mar 2011
                • 1257

                I have over 7000 rounds with my MP and only had two FTE's and it was during the third day of a desert trip without cleaning or oiling after about 700 flawless rounds. I re-oiled and shot another 300-400 flawless rounds. I make sure it is lubed and never have a problem with my MP which is my favorite and "Go-To" handgun!

                Comment

                • #9
                  gwanghoops
                  Senior Member
                  • Feb 2012
                  • 1452

                  I had this happen several times with Reliant (new) ammo (3 boxes). Tried re-racking as the first round and it did the same thing. Tried putting the same rounds in the middle of a magazine and it did the same thing. Didn't try different magazines.

                  Shot over 1000 rounds without a problem (except for newbie limp wristing) with a variety of typical new brass range ammo. Never used American Eagle.

                  Comment

                  • #10
                    ILVSMOG
                    insert clever title here
                    CGN Contributor - Lifetime
                    • Sep 2009
                    • 611

                    Originally posted by Clutch-n-Throttle
                    When I owned an M&P45, I had the same FTF. It would happen occasionally.

                    A little filing can "fix" the situation.
                    Where did you file on it? I don't mess with polymer guns much. I didn't make it to the range today, but with the rain I should have a few days off. I'll put another couple hundred through it and report back.

                    Comment

                    • #11
                      Clutch-n-Throttle
                      Member
                      • May 2011
                      • 277

                      Originally posted by ILVSMOG
                      Where did you file on it? I don't mess with polymer guns much. I didn't make it to the range today, but with the rain I should have a few days off. I'll put another couple hundred through it and report back.
                      PM'd
                      CLEVERLY DISGUISED AS A RESPONSIBLE ADULT

                      Comment

                      • #12
                        ILVSMOG
                        insert clever title here
                        CGN Contributor - Lifetime
                        • Sep 2009
                        • 611

                        Well, after a little adjustment to the extractor, I went back to the range and ran some more ammo through the M&P. It seems to be all good now. Hopefully that's the end of that problem. Thanks everybody!

                        Comment

                        Working...
                        UA-8071174-1