Bore Brush s&w 500 ?

[TacFan]

I can't seem to find a bore brush for my new s&w 500 ? Anyone know if they even make them ?

thanks

[sloguy]

use a shotgun brush.

[SVTNate]

Soak the bore in Hoppe's #9, take the gun to the Honda Center, and drive the Zamboni through it several times.

Call Fowler's Gun Room in Orange and check with them... they typically have a very good selection of bore brushes. So does their sister store in Westminster (the Stockade)

[Fjold]

Look over by the blackpowder supplies they usually have 50 cal brushes there.

[CSACANNONEER]

If you're near me, I'll give you a couple that are too warn out for my BMGs. Since the bore of your 500 is .010 smaller than BMG bores, they should work fine.

[mike100]

I often use a .500 brush for my 44 and 45 guns. helps if you shoot lead.

28 ga shotgun diameter is .55 - maybe try that if you have hard deposits.

[TonyM]

I have a couple 50 cal brushes, but I use the boresnake and the Otis kit and have no problems with my barrel being dirty.

[rorschach]

I have a .50BMG brush I bought at a gunshow, works OK.