My m&p blocked mags

[Panchira!]

Hey guys! Well I finally had some time to sit down and block my standard cap mags. Well block no but rod yes! I had some threaded aluminum tubes from my RC rock crawling days the idea popes right into my head! Now because the s&w followers have a "bulge" in the middle I figure I'd drill and tap and glue (super glue) in a m3 set screw (long set screw) cut the rod to the right length and super glued into place too. Bam rodded 10round mags. I tested every mag to force a 11th round in and no dice! I tried so hard I dented one round! These things are permanent! If you remove them they will break the follower! Anyways onto the pics:

[billybob_jcv]

What does the face of the follower look like now? Is there a hole in it that wasn't there before? I'm guessing that method might be a problem if the gun was a model that is known to be sensitive to FTF issues??

[Panchira!]

The top of the follower has no holes. I only driller around a 1/4". Until I got shavings coming out of the spring hole. Threaded about 1/2 of a 1/4" and used super glue and threaded it in works great although aperantly the followers twist side to side and the rod catches on the spring base plate I'll probably shave down that part of the spring base. I'll get pics up later tomorrow.

[echang86]

I like it. I might try something like this so I can use the 10-8 M&P base pads. The factory magazines are annoying to index.

[Mr310]

The last picture reminded me of the ones that sorostitutes put up on facebook of their feet in a circle.

I like this one way more.

[Cali-Shooter]

Nice job for Kali compliance. Nothing like a good ol' homemade magazine.

[Panchira!]

Thanks guys! They are working great!

[den888]

Looks great!