Unconfigured Ad Widget

Collapse

GP 100 Issue

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • LoadedM1A
    Member
    • Jul 2009
    • 117

    GP 100 Issue

    I bought a used GP 100 for home defense, the first thing I did was clean it and then leave it loaded in the closet. When I leave Fiocchi 357 ammo in it for extended periods of time (1 week or so) the rounds start to oxidize in the wheel and become harder and harder to get out. I have the blued version if that makes any difference.

    I've cleaned the gun twice with hoppes and still get the same result. Wiping out the cylinders with a piece of cloth helps slow the process.

    Why is this happening and what can I do to stop it?
  • #2
    reidnez
    Senior Member
    • Mar 2009
    • 1852

    Well, the obvious answer is that the solvent is reacting with the cartridges somehow. You generally don't want to leave solvent in the gun after you're done cleaning; wipe it all out and instead store it with a light coat of oil. However, I wouldn't advise leaving the chambers coated with anything--not only because it may be causing what you are experiencing, but also because solvents and oils have the potential to seep into primers and cause dud rounds. That is definitely not what you want in a home defense piece.
    Believe those who are seeking the truth. Doubt those who find it. -Andre Gide

    Comment

    • #3
      tiko
      Senior Member
      • Jan 2008
      • 866

      Clean the cylinder real good, the polished cylinder will make the rounds slide in/out easy, no need to use oil.
      Do it yourself.

      Comment

      • #4
        Miltiades
        Senior Member
        • Dec 2006
        • 1149

        Suggestion

        This sounds very unusual to me. I have left lots of different ammo in many revolvers for years and have never seen this problem.

        I would try a different brand of ammunition than Fiocchi. In .357 defensive ammo I use Speer or Remington and haven't had any problems.

        Comment

        • #5
          Greg-Dawg
          Banned
          • Oct 2006
          • 7793

          After cleaning, use a an air spray or blow dryer to dry out the revolver.

          Comment

          • #6
            redhemi
            Veteran Member
            • Nov 2009
            • 2970

            I have a GP100 in stainless and I leave it loaded also and have had no problems like that but as stated before the CYL should be dry no solvent or oil this could be the problem also change ammo to see if this is might be it also. Good luck,Redhemi

            Comment

            • #7
              LoadedM1A
              Member
              • Jul 2009
              • 117

              I recleaned the cylinders and wiped them out with a cloth, whenever I can find some more ammo I'll give that a shot. I did that last night and haven't noticed anything as of today so hopefully that will fix it.

              I use a generouse amount of solvent to clean but it was never put away dirpping or with anything more than a light residue left on the weapon.

              I think the previous owner might have done something funky with it and I'm experiencing problems as a result.

              Comment

              • #8
                22popnsplat
                Senior Member
                • May 2008
                • 1042

                clean dry chambers and nickle plated brass ammo .

                Comment

                • #9
                  Packy14
                  Calguns Addict
                  • Jul 2008
                  • 5312

                  Fiocchi = trash
                  NRA Lifetime Member

                  1A-2A = -1A

                  Comment

                  Working...
                  UA-8071174-1