Glock 43 optic milling

[firemanjoe]

Getting ready to send out my G43 slide for milling to mount a RMRcc. Considering Primary Machine or Glockstore to do the work. Anyone with experiences either way?

[Peahi2]

Unless your heart is totally set on milling... why not get an optic cut slide and keep your original slide un molested. But primary machine has a solid reputation.

I purchased a nice Norsso G26 slide a while back...top quality I must say. There were many others I considered.

[firemanjoe]

Unless your heart is totally set on milling... why not get an optic cut slide and keep your original slide un molested. But primary machine has a solid reputation.

I purchased a nice Norsso G26 slide a while back...top quality I must say. There were many others I considered.

I wanted to keep it with my original slide because this is my primary carry gun.

[Rover]

Do you already own the RMRcc? If not I'm maybe consider a different optic, one with the Shield RMS footprint, so some variation thereof.

If you're set on the RMRcc, just make sure they machine the slide with the raised threaded bosses that Trijicon specifies. I know Agency does it that way, without those bosses all the recoil forces are absorbed by the screws, and they like to snap.

[firemanjoe]

Do you already own the RMRcc? If not I'm maybe consider a different optic, one with the Shield RMS footprint, so some variation thereof.

If you're set on the RMRcc, just make sure they machine the slide with the raised threaded bosses that Trijicon specifies. I know Agency does it that way, without those bosses all the recoil forces are absorbed by the screws, and they like to snap.

I have already purchased the RMRcc. I know it?s a proprietary foot print and requires some special consideration but I already have RMRs on other full size pistols and don?t want to change it up too much.

[BEE]

Avoid GlockStore. Just all bad.

Thumbs up for Primary Machine, can't go wrong with them. Just matter how long their lead times are and how long you're waiting to wait.

Wager Machine Works, Link, father & son operation and are quite popular on social media. Lead times are rather short compared to the more known bigger names like PM.

TwoSee, Link, also getting popularity and have short/fast lead times.

[46knuck]

I was going to mill also but put the shim on my 43x and really you hardly know it is even there. Shim is cheap try it first maybe?

[firemanjoe]

I was going to mill also but put the shim on my 43x and really you hardly know it is even there. Shim is cheap try it first maybe?

I have just a standard G43. Not a 43x or mos