GP100 Owners - Trigger binding/not pulling

[So Steeze]

[Sir Toast]

Try cleaning under the ejection tray, or whatever it is called. If a shaving got under there, or other debris, it will prevent the cylinder from turning and obviously the trigger from coming back.

I had that problem and the Calguns forum helped me figure it out. It doesn't take much under that little part that pushes the empty cases out the back of the cylinder to bind it up.

Good luck.

[So Steeze]

Try cleaning under the ejection tray, or whatever it is called. If a shaving got under there, or other debris, it will prevent the cylinder from turning and obviously the trigger from coming back.

I had that problem and the Calguns forum helped me figure it out. It doesn't take much under that little part that pushes the empty cases out the back of the cylinder to bind it up.

Good luck.

Can you look at this and show me? Are you talking about 18?

https://www.gunpartscorp.com/Pub/schematic/Ruger_GP100_schem.jpg

Edit: You are a genius, I cleaned the inside of the cylinder and crane/yoke, as well as the ejector rod and it all fit back together without issue. I don't know why a little bit of dirtiness wrecked the whole damn reassembly process, but it all works now. Thank you!

[JTROKS]

If you’re still having problem let me know and I’ll disassemble my GP100. It’s been a while since she had complete strip, deep clean and lubed.

[So Steeze]

Problem solved I guess it just needed a cleaning, which is kind of weird to me. But thanks everyone for the help

[Sir Toast]

Can you look at this and show me? Are you talking about 18?

https://www.gunpartscorp.com/Pub/schematic/Ruger_GP100_schem.jpg

Edit: You are a genius, I cleaned the inside of the cylinder and crane/yoke, as well as the ejector rod and it all fit back together without issue. I don't know why a little bit of dirtiness wrecked the whole damn reassembly process, but it all works now. Thank you!

You had me at genius. Glad it worked out.