Holosun install on Dagger slide

[bmaksdad]

[LVcleef]

I used the longer screws with Vibra-tite. Just passed the 500 round mark and it's holding up fine. I let the stuff set for 15 min before tightening, and waited overnight before shooting it. Don't rush and good luck with the install!

[NewbieDave]

Not sure on PSA slide but some traditional RMR cut slide has the right mounting hole going into the extractor channel. Just make sure whichever screw you use doesn't tap inro that channel.

NB

[bmaksdad]

Great, thank you for the reply, much appreciated. Did you use your factory barrel and guide rod? That’s what I’m planning on doing. I figure the more aftermarket non-Glock parts you start adding can lead to issues. I thought about getting a Faxon barrel or Grey Ghost but I don’t really see the need to spend the extra money when the OEM parts have been solid.

[sigstroker]

PSA also has barrels. They have cheap threaded barrels, but that doesn't help kalis.

[jsanch03]

[LVcleef]

My Dagger slide was installed on a stock Gen 2 with stock barrel and guide rod. Runs like a champ so far.

[BuckshotBob]

I installed the longer screws on the dagger slide for my Holosun 507C-X2. I went with a Rival Arms spiral fluted barrel and a stock guide rod on a stock G19 frame. No issues so far but only have had the chance to take it out once.